User manual

137ALI-HVR3000H Series 960H Hybrid+ DVR User Manual
APPENDIX C: HDD INSTALLATION
APPENDIXC HDD Installation
The following procedures illustrate hard disk drive (HDD) installation in a ALI-HVR3000H series DVR without an HDD. If you
purchased your DVR without a HDD, or you want to replace the HDD installed in your DVR, use this procedure as a guideline.
C.1 DVR compatible HDDs
For the best performance of your system, install only a high-reliability security grade HDD. Security grade HDDs are designed to
stream video eciently.
C.2 HDD Installation
The ALI-HVR3004H and ALI-HVR3008H DVRs the will accommodate one internal HDD. The HDD attaches to the chassis with four
screws inserted up through the underside of the chassis. The ALI-HVR3016H DVR can hold 2 HDDs.
Cables and screws needed to install the HDD are provided.
11.5.1 ALI-HVR3004HandALI-HVR3008HHDDinstallation
CAUTION

Follow recommended electrostatic discharge (ESD) guidelines while performing this procedure. Install the HDD in a static-free
environment, wearing a certied ESD wrist strap. If a static free environment and ESD wrist strap is not available, touch the bare
metal of the DVR chassis frequently when installing the drive to dissipate the static charge naturally generated on your skin and
clothing and avoid touching electronic components.
1. Power o the DVR, if necessary, then disconnect the power adapter from the back of the DVR.
2. Remove the top cover from the DVR by removing the six cover screws. Two cover screws are located on each side, and two are
located on the back panel. See the drawing below. Save the screws for use later.