Setup guide

5 www.Observint.com

10. Click OK when the recording mode for each camera is selected. The Wizard will close and the DVR will present the Live View display.

For more information about the Live View display, refer to the user manual.

4-channel Live View display

Step 4. Using the Menu system

After the initial setup of your DVR using the Wizard, the Menus interface enables you to rene your conguration settings and expand the

functionality of the system. To use most menus, the user must log into the DVR system, either locally or remotely, with administrative

privileges.

To open the Menu system from the Live View screen, right click anywhere in the screen, then select Menu

9. In the camera setup wizard, you can initially select the recording mode for each camera attached to the camera input BNC connectors.

To use this menu:

Click here to open

the camera

graphical menu

a. In the Camera menu shown above, open graphical menu select the camera to congure. “1” (Analog 1) identies the camera

plugged into the camera input BNC connector 1, “2” (Analog 2) identies the camera on BNC connector 2, etc.

b. To congure the camera for recording, click the Start Recording box to check it, then click the bullet for either Normal

(continuous) mode recording or Motion Detection mode recording.

c. Do one of the following:

* To copy these recording settings to other cameras connected to the DVR, click Copy, then select the other cameras to you

want to apply the settings to.

* To congure another camera dierently, open the Camera graphical menu and select the next camera to congure. Then

repeat the steps above to congure the recording mode for that camera. You can also Copy these settings to other cameras.

d. After conguring the recording mode for each camera, click OK to conrm your settings and close the Wizard.