Setup guide

4 www.Observint.com

Generally, it is preferable to setup the DVR with a xed network settings, if possible, to assure the DVR has an unchanging IP address

for remote logins. To enable xed network settings, uncheck the Enable DHCP box, then edit the appropriate elds to change the

settings. Consult with your network administrator to determine the best network settings for your DVR. When nished, click Next.

8. Click Next after you congured the network parameters. The HDD management Wizard window will open. If a new DVR is shipped

with a pre-congured HDD, nothing needs to be done in this window. If you installed an HDD or replaced the HDD, select (check the

box for) the HDD, then click Init to setup the disk for the DVR. NOTE: Init will erase all data from the disk. When the initialization is

complete, click Next to continue.

Observint strongly recommends that you change the default admin user password to improve the security of your surveillance system.

To change the admin password, check the New Admin Password box, then enter the new password in the New Password and

Conrm elds. Record your new password and save it in a secure place for reference later.

5. Click the Next button to open the date and time settings window.

6. In the date and time setup window, click the eld you want to change, then use the drop-down list or setup aid to select the

appropriate values. Click Next to conrm your settings or Cancel to discard them and open the network setup Wizard window.

7. In the Network setup Wizard window, click the eld value you want to change, then use the pop-up aid to enter a new value. By

default, the DVR uses DHCP (Dynamic Host Conguration Processor) to acquire compatible (dynamic, changeable) network settings

from a network DHCP server.