Setup guide

5 www.Observint.com

In the screen below, other elds were changed appropriately, and the Preferred DNS Server address was set to 8.8.8.8.

8. Click Next after you congured the network parameters. In the screen shown below, you can change the Server Port, HTTP port, and

RSTP port if using these port numbers interferes with other devices on your network. In most cases, they will not. To change a port

number, click the eld, then enter the new number using the pop-up soft keyboard. For more information about how to change these

ports, refer to the ALI-HVR3000H DVR User Manual and credible sources on the Internet.

5. In the date and time setup window, click the eld you want to change, then use the drop-down list or setup aid to select the

appropriate values. For instance, click the Time Zone eld, then highlight Time Zone for your DVR.

Click the other elds in the window and make the appropriate changes, if needed.

6. Click Next to conrm your settings or Cancel to discard them and open the network setup Wizard window.

7. In the Network setup Wizard window, click the eld value you want to change, then use the pop-up aid to enter a new value. By

default, the DVR uses DHCP (Dynamic Host Conguration Processor) to acquire compatible (dynamic, changeable) network settings

from a network DHCP server.

Generally, it is preferable to setup the DVR with xed network settings, if possible, to assure the DVR has an unchanging IP address for

remote logins. To enable xed network settings, uncheck the Enable DHCP checkbox, then edit the appropriate elds to change the

settings. Consult with your network administrator to determine the best network settings for your DVR. When nished, click Next.

In the screen below, the Enable DHCP checkbox was cleared and the IPV4 Address was changed to 192.168.75.8.