Quick Start Guide

– 2 –
Quick Start Guide
1.
Connect the AC power adapter to the DC power jack
Check AP LEDs
1. Power LED — on green for normal operation.
2. 2.4GHz and 5GHz LEDs — on green for radio enabled.
3.
3
Hardware Specifications
on the AP and then plug the adapter into a nearby AC
power source.
Bluetooth LED — on green for bluetooth enabled.
1 2.5GE LAN/WAN port Support 10/100/1000M/2.5Gbps
1 2.5GE WAN port Support 10/100/1000M/2.5Gbps
1 Console RJ45 port
2 USB2.0 port(include the side one)
1 Default button
Port Description
DC 12 V
WAN/
L AN(PoE)
WAN/ (PoE)
CON SOLE
Def ault
1 DC port
Size(WxDxH) 201x195x39.8mm
Weight 0.7kg
Temperature Working：0° C
to
45° C
Storage: -20° C to 60° C
Humidity 5% to 95% (No-condensation)
IP rating
PoE Dual Ethernet ports support PoE,
802.3 at power supply
DC input 12V DC
IP31
150200002232H R03
This device complies with Part 15 of the FCC Rules.Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
is encouraged to try to correct the interference by one or more of
thefollowing measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for
an uncontrolled environment and it also complies with Part 15 of
the FCC RF Rules. This equipment must be installed and operated in
accordance with provided instructions and the antenna(s) used for
this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
End-users and installers must be provided with antenna installation
instructions and consider removing the no-collocation statement.
Caution!
responsible for compliance could void the user's authority to
operate the equipment.