Instructions / Assembly

Congratulations on purchasing Model 6710-

4914SP Caribbean style hammock , pillow and

wood arc hammock stand. We hope it

provides hours of relaxation. If you have

questions regarding this product, please

contact customer service at (800) 295-6758

Hardware:

Part A – Hardware Bag

Part B - #17 by 7”L bolts (x 4)

Part C - #17 by 5 ½”L bolts (x 4)

Part D - #17 washers (x 18)

Part E - #17 lock nuts (x 10)

Part F – Carabiner clip (x 2)

Part G – Eye bolt (x 2)

Part I – 2-piece #17 wrench (x 2)

Wood Parts:

Part J – Legs (x 2)

Part K – Center braces (x 2)

Part L – Uprights (x 2)

Assembly can accomplished with one person, but for easier assembly a

second person is recommended.

The Algoma Net Company, Div. of Gleason Corp.

1525 Mueller St. Algoma, WI 54201

Email: algomasales@algomanet.com 10/2012

B C

Caribbean Style Hammock,

Matching Pillow, and Wooden Arc

Stand Combo

Model # 6710-4914SP

Weight Limit: 300 lbs

Hammock & Pillow

with attached chains

PAGE 1
Caribbean Style Hammock, Congratulations on purchasing Model 6710Caribbean style hammock , pillow and Matching Pillow, and Wooden Arc 4914SP wood arc hammock stand. We hope it provides hours of relaxation.
PAGE 2
Step 1: Locate the stand legs (Part J) and place on level surface about 3 ½ feet apart as in figure 1. The beveled edges on the bottom of the legs should face each other Beveled foot edges should face inward toward the other leg. Beveled edge Detail Step 2: Locate center braces (Part K) and place on top of the legs (Part J) so that the ends of the braces curve upward as in figure 2. Locate 5-½” bolts (Part C) and washers (Part D).
PAGE 3
Step 4: With the uprights now in place, tighten the bolts that connect the legs (Part J) to the center braces (Part K) using the included wrenches (Part I) as shown in Figure 8. Figure 8 Step 5: Locate the eye-bolts (Part G) and place through the hole on the top of the upright (Part L) with the eye facing the inside of the stand as in Figure 9. Place a washer (Part D) then a lock-nut (Part E) onto the threaded end of the eye-bolt as in Figure 10.