Instructions / Assembly

Step 1: Locate the stand legs (Part J) and place on level surface
about 3 ½ feet apart as in figure 1. The beveled edges on the
bottom of the legs should face each other
Beveled foot edges should face
inward toward the other leg.
Beveled edge
Figure 1
Detail
Step 2: Locate center braces (Part K) and place on top
of the legs (Part J) so that the ends of the braces curve
upward as in figure 2, and the larger counter sink holes
of the center braces are facing the outside. Locate 5-
½” bolts (Part C) and washers (Part D). Place washer
(Part D) onto bolt (Part C), then align holes on the top
of each center brace (Part K) with the holes on top of
leg (Part J). Place the 4 bolts through the aligned holes
as in figure 3. Locate 4 more washers (Part D), and 4
lock-nuts (Part E). Place the washer (Part D) on the
end of the bolts (Part C) and finger tighten with the
lock-nut (Part E). Do not securely tighten at this time.
Figure 2
Figure 3
Step 3: Locate the upright sections (Part L) and place
between the two center brace pieces (Part K) as shown in
Figure 4. Align the two holes of Part L with the two holes
in Part K. Place a washer (Part D) onto the 7” bolts (Part
B) and tap through the center brace and upright pieces as
shown in Figure 5. Place another washer (Part D) and
lock-nut (Part E) on the end of the bolt as shown in Figure
6, then tighten bolt securely using the two included
wrenches (Part I) as shown in Figure 7. Repeat this
procedure on the second bolt. Repeat procedure again
for opposite upright.
Figure 4
Figure 5
Figure 6 Figure 7
Larger countersunk
holes to the outside