User guide

Configuring Client Call Recorder (Options Description)
Client Call Recorder Installation and User Guide 31
AuxBox Relay
Each AuxBox call recorder provides one or more dry contact output jacks
designed to trigger an external alerting device in the event of one or all of
the following events:
1. Ring
2. Message Waiting
3. In-Use (telephone off-hook)
4. Page
5. Save Activated (call set to be saved)
By default, the Relay Active Mode is set to All Modes. The output jack can
also be deactivated by selecting the Disabled setting.
The AuxBox Relay settings screen will vary slightly depending which model
of AuxBox you are using with Client Call Recorder. These differences are as
follows:
• If using a 4105 Analog AuxBox, configuration options for a single relay
will be displayed.
• If a 4102 Digital AuxBox or 5006 Centrex AuxBox is connected, config-
uration settings for two relays will be provided.
• The 4102 allows you to select its “Far End” audio level, to record both
ends of a conversation, or only the receiving end, and to set the speech
decoding format (uLaw for North America, aLaw for Europe)
• Since the message waiting feature can be configured on any key on a
Centrex telephone, the 5006 Centrex AuxBox needs its message wait-
ing key to be programmed by the software in order to recognize it.
Click on “Select Msg Wait Key. . .”, then push your message wait key
on your Centrex telephone.
If you are using a 4102 Digital AuxBox, please
note that software control of the output relays
requires front panel switches 2, 3 & 4 be set in
the default OFF position.