User guide

Installation and Setup: Installation Instructions
www.algosolutions.com 6
Wheel on the Adapter to release the
adjustment mechanism.
3. At the back of the IP phone, remove the
rubber plug from the Accessory Expansion
Module (AEM) port and plug it into a sim-
ilar port on the USB Dual Handset
Adapter. Note: although the AEM port is
not used, the plug’s removal is necessary
to physically mate the USB Dual Handset
Adapter to the IP Phone.
4. Align the connecting arm of the USB Dual
Handset Adapter behind the phone and
insert the supplied screws in to the top
and bottom holes of the connecting arm
of the USB Dual Handset Adapter. Tighten
until snug with a Phillips-type screwdriver.
Connect USB
Cable
5. Connect the
USB cable of
the USB Dual
Handset
Adapter to the
USB connec-
tor of the IP
Tel ep h on e.
To open stand, push Tab
down to release latch while
lifting up at other end