User guide

Regulatory Information: Two Handsets with Headset Configuration
90-00039 11
set connected directly to the IP Phone will
be inactive.
Regulatory Information
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures: reorient or relocate the
receiving antenna, increase the separation between the
equipment and receiver, connect the equipment into an
outlet on a circuit different from that to which the
receiver is connected, or consult the dealer or an
experienced radio or TV technician for help.
The user should not make changes or modifications not
expressly approved by Algo Communication Products
Ltd. Any such changes could void the user's authority to
operate the equipment.
Only the primary user can end a call. To
end a call, hang-up or press the Goodbye
key of the IP Phone.)