Owners Manual

13
PUSH TO
IGNITE
PUSH & TURN TO “HI”
Keep your face away from the grill as far as possible and pass a lit,
long stem match through the notch in the grill rack to the ports of
the burner you are trying to light. When attempting to light a burner
with a match, ensure that the correct burner control knob is used.
Position the match near the burner ports. Push and turn the control
knob to “HI”. Repeat procedure on each burner if necessary. If the
burner does not light in 4 seconds turn the knob OFF, wait 5 min-
utes and try again. If the burner will not light after several attempts
see page 25: Troubleshooting.
To assure that an IR burner is lit, very carefully
place your hand 8-10 inches away from the
burner surface. If you do not feel the heat of
the burner, shut off control knob, wait five min-
utes, and attempt to relight.
BUTTON SYMBOLS AND LOCATIONS:
IGNITER BUTTON LOCATION AND USE:
SMOKER BURNER LIGHTING:
To light the smoker burner, remove the smoker tray completely. Push and turn the smoker control knob
to the “HI” position and immediately depress the proper igniter button for your model.
(See BUTTON SYMBOLS AND LOCATIONS above).
GRILL MODEL LEFT IGNITER BUTTON USE:
ALX2-30
ALX2-30 SZ
Not Applicable.
ALX2-42
ALX2-42 SZ
LEFT U-BURNER (or SEAR-ZONE™),
SMOKER BURNER.
ALX2-56
ALX2-56 SZ
ALL GRILL SURFACE BURNERS,
SMOKER BURNER.
ALX2-56 BFG
LEFT ROTISSERIE, SEAR-ZONE™ IR-BURNER,
CENTER / LEFT U-BURNER.
RIGHT IGNITER BUTTON USE:
ALL BURNERS.
CENTER & RIGHT U-BURNERS, ROTISSERIE.
ROTISSERIE, SIDE BURNERS.
RIGHT ROTISSERIE, CENTER / RIGHT U-BURNER,
RIGHT SIDE U-BURNER, SMOKER
IGNITER BUTTON SWITCH
(see use and location below)
LIGHT FIXTURES SWITCH
(on RIGHT side)
ROTISSERIE SWITCH
(on LEFT side)
CAUTION
IN SUNNY ENVIRONMENTS,
THE FLAME FROM AN IR
BURNER MAY BE IMPOSSIBLE
TO SEE.