Gas Conversion

Page 3
BARBEQUES:
A typical barbeque unit will have the following burner components:
MODEL:
BURNER QUANTITIES:
SMOKER "U" BURNER SEAR-ZONE™ ROTISSERIE SIDE BURNER
AGBQ-30 1 2 ~ 1 ~
AGBQ-30SZ 1 1 1 1 ~
AGBQ-30IR 1 ~ 2 1 ~
AGBQ-42 1 3 ~ 1 ~
AGBQ-42SZ 1 2 1 1 ~
AGBQ-56 1 3 ~ 1 2
AGBQ-56SZ 1 2 1 1 2
AGBQ-56BFG 1 3 1 1 ~
AGSB-2 ~ ~ ~ ~ 2
AGSB-SZ ~ ~ 1 ~ ~
KNOBS
FRONT PANEL
SMOKER TRAY
DRIP TRAY
STEPS:
1– Remove the knobs from the valve stems by pulling them straight out of the valve stems.
2– Remove the smoker and drip trays.
3– Remove the front panel screws (4) located at each corner (2 facing down and 2 on the upper corners)
4– Remove the front panel to expose valves, gas manifold and igniter assembly. (Figure 2)
TYPICAL BARBEQUE
Figure 1
Figure 2