Care & Use Manual

AIR SHUTTER

ADJUSTMENT CUP

SET-SCREW

U-BURNER

1” MAXIMUM

” MAXIMUM

Figure # 4

FLAME SIZE

LOW HEAT SETTING ADJUSTMENT:

NOTE: THE LOW HEAT SETTING ON

YOUR GRILL IS PRESET AT

THE FACTORY.

ADJUST ONLY IF ALTITUDE

OR ENVIRONMENTAL FAC-

TORS ARE CAUSING POOR

LOW HEAT PERFORMANCE.

ADJUSTMENT STEPS:

1. Follow lighting instructions by setting the control

knob on “HI” and allow the burner to preheat for 10

minutes.

2. Turn the control knob to “LOW” and wait for the

burner temperature to drop and stabilize.

3. Attempting adjustment at any setting other than

LOW can create a dangerous condition.

4. Remove knob by pulling straight away from control

panel.

5. Insert a small blade screwdriver into the valve stem

to begin the adjustment.

6. Turn counter-clockwise to INCREASE the low heat

flame using pliers to hold the stem securely. (see

figure # 5)

7. Adjust the flames so the burner is fully lit around the

perimeter when the know is in the LOW position.

8. Once proper adjustment is reached, reattach the

knob by pushing onto stem.

WARNING

NEVER ADJUST THE BURNER SO LOW THAT IT MAY

GO OUT DURING USE. DO NOT OPERATE THE

GRILL WITH THE LOW HEAT SCREW REMOVED.

GAS CAN ESCAPE AND CAUSE A POTENTIALLY

HAZARDOUS CONDITION.

Figure # 5