Installation Sheet

STEP 8:
Install the new piping assembly
on the ALXE BBQ side
consisting of :
 (1) 1/2” NPT Close Nipple
 (1) 1/2” NPT Tee
 (1) 1/2” NPT x 3/8” OD
Compression Fitting
 3/8” Ø x 42” Flex hose.
For LP systems only, reinstall
the existing:
 1/2” NPT x 3/8” ODF
Reducer
That was removed on STEP 7.
(see picture 6)
STEP 9:
Route the 3/8” Ø x 42”
Flex Hose over the ALXE BBQ’s
Rotisserie Motor Housing and
insert through the 11/16”
grommet installed in STEP 2.
(see picture 7)
STEP 10:
Connect the 3/8” Flex Hose to
the 1/2” NPT x 3/8” OD
Compression Fitting already
installed in the AXESB-2C side
burner unit.
(see picture 8)
FINISHING:
Pressure test all fittings with
soapy water to ensure that no
LP or NG gas leaks are present.
Finish by closing off and re-
installing all panels on the back
sides of the AXESB-2C and the
ALXE BBQ unit.
Your AXESB-2C is ready for
use.
Picture 6
Pressure
Regulator
1/2” NPT
Nipple
1/2” NPT
Tee
1/2” NPT x 3/8”
OD Compression
1/2” NPT x 3/8”
ODF Reducer (LP)
3/8”Ø x 42”
Flex Hose
Picture 7
Rotisserie
Motor
3/8”Ø x 42”
Flex Hose
11/16ӯ
Grommet
Picture 8
Pressure
Regulator
1/2”NPT x 3/8”OD
Compression
3/8”Ø x 42”
Flex Hose