User Manual

BURNER BLOWS OUT:

First determine if the problem is being caused by location. If location is subject to high winds, reposition grill to

provide some protection by placing the back of the grill toward the wind.

Check the gas supply and flame characteristic according to the procedure under Low / Insufficient Heat.

Check to ensure that burners are correctly positioned in the grill according to the procedure on page 5.

Correctly installed burners should be seated firmly with no side-to-side movement.

ROTISSERIE WON’T LIGHT:

Follow the same procedure as “grill won’t light”, on page 14, to diagnose problems with the Rotisserie IR

burner. The IR burner flame may be hard to see in bright sunny conditions.

SMOKER BURNER WON’T LIGHT:

Follow the same procedure as “grill won’t light”, on page 14, to diagnose problems with the Smoker burner.

Remove the wood chip tray to better see the smoker burner flame.

When using the smoker with the main grill burners, the smoker burner should be lit first and allowed to preheat

before lighting the grill burners.

GRILL GETS TOO HOT:

IF THE GRILL GETS TOO HOT, TURN IT OFF IMMEDIATELY AND ALLOW IT TO COOL.

Perform a leak test according to the procedure on page 11. If leaks cannot be corrected, call for service before

attempting to use the grill.

LIGHTS DON’T WORK:

Check that power is connected and that the GFCI has not tripped.

LIGHT BULB REPLACEMENT:

NOTE: Disconnect all power to your

Alfresco

™ Gourmet grill before any service or light bulb replacement

is performed. There are two types of lights on your ALXE grill, incandescent in the cooking area (Figure #9)

and LED panel lights under the control panel bullnose (Figure #10).The Bullnose lighting system requires

eplacing the entire LED array as an assembly.

Incandescent light bulbs are located on the left and right side of the rear hood above the cooking area. The

area around the light fixtures and the light fixtures themselves become extremely hot during grill operation with

or without the lights being turned on.

BEFORE REPLACING ANY INCANDESCENT LIGHT BULBS, ALLOW SUFFICIENT TIME FOR THE

FIXTURES TO COOL DOWN IF THE LIGHTS OR THE GRILL WAS TURNED ON, OR BOTH.

Incandescent Light bulbs can reach several hundred degrees when operating, so allow plenty of time for them

to cool down.

Figure # 10

Figure # 9

G940120-G9 BASE

40W-120 VAC

Part# 210-0317

LED ASSEMBLY

BBQ MODEL: PART NUMBER:

LXE-30 510-0998

ALXE-36 510-0962

ALXE-42 510-1000

ALXE-56 510-1001

ALXE-56 BFG 510-1002