Owner's Manual
14 
REAR  BURNER:  Repeat  the  same operation 
as explained on the front burner but using the 
side burner left hand control knob. 
If  either  burner  does  not  light  within  4 
seconds,  turn  knob  to  “OFF”  and  wait  5 
minutes  to  allow  any  accumulated  gas  to 
dissipate before trying again. 
NOTE:  To ensure proper spark ignition, do not change the gap between  the  electrode wires  and the 
burners. The optimum gap is preset at the factory between 1/8” and 3/16”. 
ROTISSERIE BURNER LIGHTING: 
Open  the  hood,  press  the  proper  igniter  button  (see  previous 
page)  and  then  turn  the  control knob 90° counter-clockwise  to 
the “ON” position. If the burner does not light within 4 seconds, 
turn the control knob to “OFF”, wait five minutes and attempt to 
relight. 
After  your  first  use  of  the  rotisserie  burner  it  is  likely  that  the 
stainless  steel  adjacent  and  directly  above  the  burner  will 
darken  to  a  dark  blue  color.  This  is  a  normal  property  of  the 
corrosion  resistant  type  304  stainless  steel  used  in 
manufacturing the Grill and is not detrimental to its operation. 
PREHEATING THE GRILL: 
U-BURNERS: 
Preheating  the  grill  is  important  for  best  performance.  To  preheat  the  grill  when  cooking  with  the  U-
burners,  close  the  hood  after  lighting  the  burners  as  described  above.  Set  the  grill  control  knobs  on 
“MAX” for 15 minutes. 
IR-BURNERS: 
Preheating the IR burners is important to protect them from food drippings. After lighting the IR burners 
as described above, allow to preheat on “ON” for four minutes before beginning to grill. 
If your grill is equipped with a SEAR-ZONE™ IR BURNER, light and preheat the U-BURNERS first, then 
light and preheat the SEAR-ZONE™ IR BURNER. 
ROTISSERIE BURNER: 
Light  the  rotisserie  burner  as  described  in  the  lighting  instructions.  Once  lit,  the  rotisserie  burner  will 
reach cooking temperatures in about 1 minute. 
! CAUTION 
IN  SUNNY  ENVIRONMENTS,  THE 
FLAME  FROM  AN  IR  BURNER 
MAY BE IMPOSSIBLE TO SEE. 
PUSH TO 
IGNITE 
PUSH & TURN TO “MAX” 
! MISE EN GARDE 
DANS  LES  ENVIRONNEMENTS  SO-
LEILS,  LA  FLAMME  D'UN  BRÛLEUR 
IR PEUT ÊTRE IMPOSSIBLE À VOIR. 










