Gas Conversion
Page 9
PRESSURE REGULATORS:
Your barbeque grill as well as side burner unit is equipped with a dual gas supply (NG or LP sup-
ply) pressure regulator standard from the factory. It is necessary however, to reverse an internal plunger
within the regulator to allow for correct pressure to flow to the gas manifold.
Also, when converting from natural gas (NG) to liquid propane (LP) your conversion kit will include a
1/2ӯ MPT to 3/8ӯ Male Compression adapter nipple. This nipple is required to connect your regulator
to a standard propane tank and hose kit.
All pressure regulators are located on the back of the units and on the left side. ( Figures 19, 20 & 21)
(Figure 19) (Figure 20) (Figure 21)
AGSB-2 SIDE BURNER AGSB-SZ SIDE BURNER
STEPS:
1– Locate the inlet elbow (1/2” Ø black pipe elbow) and attach the hose regulator nipple using gas
approved gas plumbing seal of yellow Teflon® tape. (This step only applies to NG to LP conversion)
(Figure 22)
PRESSURE
REGULATOR
FITTING—HOSE ADAPTOR
1/2ӯ NPT x 3/8ӯ COMP.
(NG TO LP ONLY!)
(Figure 22)
BARBEQUE GRILL
ROTATE ELBOW
IF NECESSARY