Built In Installation Instructions

2
ALF-PZA-BIA KIT FOR BUILT IN CONSTRUCTION
KIT INSTALLATION:
Once you have removed all the packing material that your Alfresco™ Pizza Oven was shipped with,
the built-in BIA-Kit can be installed on the unit. The Built-in conversion Kit consists of 3 items:
• A high pitched top cover
• A Type B, adjustable, double-walled vent pipe
• A Type B vent cap.
The installation can be done by simply removing the top
cover of the ALF-PZA unit and replacing it with the built-in
hood.
• Remover the top by lifting straight up. (Do not remove
the top radiant stone, it’s designed to stay there)
(See Figure # 1)
• Install the BIA-Kit Hood by laying it on top and sliding
forward until all the screw holes located in it’s sides
and back line-up correctly with the holes in the body
of the ALF-PZA.
(See Figure # 2)
• Fasten all 9 self tapping screws to permanently fix the
BIA Hood to the body of the ALF-PZA Unit.
Once the BIA Hood is installed, it should look like
Figure # 3. The vent flue and vent cap (TYPE B
Rated) will be added later during construction of
the non-combustible built-in enclosure.
Figure # 1
TOP COVER
ALF-PZA UNIT
LIFT UP
BIA HOOD
F
O
R
W
A
R
D
D
O
W
N
Figure # 2
Figure # 3
VENT CAP
VENT FLUE VENT FLUE
SCREWS
AROUND
PERIMETER