Use and Care Manual

7
ASSEMBLY INSTRUCTIONS
Hardware Used
1
2
x 4
E
J
F
H
K
G
Hardware Used
Bolt (6*22mm)
M
Q
M
x 8
Bolt(6*25mm)
Washer (M6)
x 4
P
Washer (M6)
x 8
P
.elpoepowtottsebsitIETON : assemble the fire pit with
2 Connect Gas Tank Bracket J to the holes located at the bottom of)(.
-(* )/ ()().Side Panels E and F using 2 Bolt 6 22mm Washer M6 Q
()Then slide ends of Gas Tank Support K onto the right side of the Gas
(Tank Bracket J) and align the 2 holes on the front of the Gas Tank
)((Support K) with the 2 holes in the Door Frame H and secure it to the
-(* )/ ()().bottom piece of the Door Frame using 2 Bolt 6 22mm Washer M6 Q
E
G
hole1
hole2
H
F
(NOTE:Don't put the Bolts on too tight.)
(NOTE:Don't put the Bolts on too tight.)
1.Connect Side Panels E F G H with Bolt 6 25mm
Washer M6 M as shown in Figure 1 using Allen
Wrench make sure that holes1 2 can be found on the
side panels and assemble as Figure 1 the two holes
help fix the Gas Tank Bracket and Gas Tank Support in
the Step 2
(,, ,) (* )/
()()
,(.
,
.)
M
Q
Q