Use and Care Manual

OPERATION INSTRUCTIONS

Leak Test

1 Make 2 3 oz of leak test solution one part liquid dishwashing detergent and three parts water .)(.-.

2 Apply several drops of solution where hose attaches to regulator..

3 Apply several drops of solution where regulator connects to cylinder..

4 Make sure all fire pit and light valves are OFF..

5 Turn cylinder valve ON..

If bubbles appear at any connection there is a leak

1 Turn cylinder valve OFF..

2 If leak is at hose regulator connection tighten connection and perform another leak test If bubbles.:/.

continue appearing the hose should be returned to the place of purchase.,

3 If leak is at regulator cylinder valve connection disconnect reconnect and perform another leak

test If you continue to see bubbles after several attempts cylinder valve is defective and should be

,,:/.

returned to cylinder place of purchase.

If NO bubbles appear at any connection the connections are secure .,

NOTE Whenever gas connections are loosened or removed you must perform a complete leak test:,

Complete installation.

Regulator Cylinder/

connection

Hose Regulator/

connection

Perform all leak tests outdoors.

Extinguish all open flames.

NEVER leak test when smoking.

Do not use the fire pit until all connections have been

leak tested and do not leak.

WARNING