Instructions / Assembly

A. BEFORE LIGHTING, smell all around the unit
because some gas is heavier than air and will
B. WHAT TO DO IF YOU SMELL GAS
1. Shut off the gas to the appliance .
ame .
3. If odor continues, immediately call your gas
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, DO NOT try to repair it.
explosion.
FOR YOUR SAFETY, READ BEFORE LIGHTING
1. STOP! Read the safety information above.
2.
3.
5. If
4.
the bur ner does not light before the match goes out,
immediately turn the control knob to the OFF position.
6.
gas, and repeat steps 1-4 above.
7. If your burner fails to light again, turn the control knob
to the OFF position and contact your dealer or gas
supplier.
8. To extinguish your gas burner, turn the control knob
to the OFF position. Be sure the control knob is turned
fully off to avoid any gas leakage.
OPERATING THE UNIT - LIGHTING AND EXTINGUISHING
MANUAL (MATCH) LIGHTING INSTRUCTIONS
WARNING: IF YOU DO NOT FOLLOW THESE INSTR UCTIONS EXACTLY, A FIRE OR EXPLOSION MAY
RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
Fig. 15-2
Fig. 15-3
ON OFF
Push and slowly turn the control knob to the ON
position (see Fig. 15-3). Your burner should light.
Fig. 15-1
Apply match, then turn on gas
Observe the flame height when lit. Flame should be
3 to 13 inches high (see Fig 15-4).
Fig. 15-3 Fig. 15-3 Fig. 15-3 Fig. 15-4
Lay a lighted long-stem match on the surface of the
decorative media near the burner ring (do not hold the
match in your hand) (Fig. 15-1) or use a lighted
long-necked butane lighter (Fig. 15-2)
long-necked butane lighter