Instructions / Assembly

3
Figure 1
Remove all protective materi-
al carefully. Avoid cutting the
surface of the furniture while re-
moving the packaging material.
From the inside of the leg connect-
or brace (C), loosely attach the leg
connector brace (C) to the legs (B)
with the bolts (J) through the small
flat washers (K), small lock wash-
ers (L) using hex screw driver (O).
As shown in figure 1.
DO NOT TIGHTEN BOLTS AT THIS
POINTS.
Carefully turn the table top
(A) upside down on a soft
surface. Align the holes in the legs
(B) with the holes in the table top
(A). Loosely secure table legs (B)
to table top (A) by the bolts (D)
through large flat washers (E),
large lock washers (F) and nuts (G)
using wrench (N).
As shown in figure 2.
DO NOT TIGHTEN BOLTS AT THIS
POINTS.
2
Check the alignment of all ta-
ble legs (B), and adjust if nec-
essary. Once the alignment is cor-
rect and all bolts (D&J) and nuts
(G) are in place, tighten all nuts (G)
using wrench (N) . Cover all bolts
(D) and nuts (G) with bolt cover (M)
and nut covers (H) .
With the help of another person,
carefully turn the table to the up-
right position.
The table is ready for your enjoy-
ment.
3
1
A
C
B
Figure 2
C
B
C
H
G
F
E
D
B
A
C
Figure 3