Use and Care Manual

6
ASSEMBLY

9ZWSYMJFXXJRGQJI

UFSJQX IT\SYMJSFYYFHM/>½-Å³¿½
½½½½
½

H

YT*>g½½EG^FQNLSNSLMTQJXFYJFHMJSITK/>
-Å³¿½\NYMMTQJXFYYMJGTYYTRTK*>g¶.SXJWYB¿½
P
YMWTZLM
7>¶g³½
Q
NSYT MTQJX. TNLMYJSgentQ^\NYMHex½7³gU½
W

9MJSFYYFHM/>½-Å³¿½,y YTYMJ1JLTK³½*>g½
D
b^
FQNLSNSLMTQJNSKWTSYTK
/>½-Å³¿½,y \NYM hTQJ NS 1JL .SXJWY
¿½
P
½YMWTZLM7>¶g³½
Q
FSIYMJSNSYTYMJ MTQJ.
9NLMYJS\NYMHex 7³gU  
W

>³_Í>³g½1¶g_[½ P 'TQY]RR]

Q

<FXMJW2]


2
2
3
4
3
M
T
N
M
Stud (8x30mm) x 4
N Washer/Spring Washer/Nut (8mm) x 4
T Plastic Cap (M8) x 4
3
Hardware Used:
Place Table Top C so underside faces up. Screw 4
Studs M into
the holes on the Table Top with Screwdriver U. Then carefully
turn the assembled fire pit base upside-down and align the holes
in the top of the Legs with the Studs in the Table Top.
Place the holes over the Studs and secure each with Washer/
Spring Washer/Nut N as illustrated. Tighten with Wrench V.
Then place Plastic Caps T over Nuts.
WARNING:
This fire pit is constructed of aluminum, a
relatively soft, flexible metal. Do not sit,
stand, or lean heavily on the top of the fire
pit, which can cause bending or warping.