Use and Care Manual

Table Of Contents

ASSEMBLY

Hardware Used:

PREPARATION

Before beginning assembly, empty contents of carton and make sure all parts are present. Place all parts on a soft, level

surface for assembly. NOTE: It is best to use TWO PEOPLE to assemble this gas fire pit.

Estimated Assembly Time: 60 Minutes | DO NOT over tighten hardware!

O Stud (6x40mm) x 12

Q Washer (M6) x 12

R Spring Washer (M6) x 12

S Nut (M6) x 12

Assemble the fire pit base: Locate Door Panel D, three Side

Panels E, Door Frame Leg F, and two Support Legs G.

Screw Studs O into the holes in the sides of all four legs,

including the leg pre-assembled to the door.

Beginning with Door Frame Leg F, join the legs and panels

together by fitting the holes on the sides of the Side Panels onto

the Studs installed earlier.

To secure the Legs to the Panels, place a Washer Q then a Spring

Washer R onto each Stud, then thread a Nut S onto each Stud.

Wait to fully tighten the hardware until the entire base is

assembled.

Then, firmly tighten all Nuts with the Wrench U, but DO NOT

OVERTIGHTEN.

Nut

Leg

Side Panel

Spring

Washer

Holes