Use and Care Manual

Table Of Contents

ASSEMBLY

Step 5

Put Bolts(G) into the hole on the inner ring of Rotaty Ring(B),then screw

nuts(G) on the opposite side and tighten it with Cross Srewdriver(N) and

Wrench(M).Note the screw should enter from the large circle of the

tapered hole on Rotaty Ring to the small circle

Step 6

Turn the Rotaty Ring(B) so that the screw on Rotaty Ring is upward, and then

align holes in the outer ring of Rotaty Ring(B) with the hole on the Rotary

Table(A).

Insert Bolts(H) into the holes and tighten them with Cross Srewdriver(N) .