Use and Care Manual

Table Of Contents

ASSEMBLY

Step 4

NOTE: To HOLD the legs together in positon, the LEGS SUPPORT

PANELS WILL OVERLAP AT ALL 04 (four) CORNERs.

First, attach the Leg Support(D) with Groove End to the Studs(J) and then

attach Support Panel(D) without Groove End to Studs(J), together.

Then affix the Leg Support(D) to the table legs with the Washers, Spring

Washers and Nuts(K) using the Wrench(M).

DO NOT tighten, yet . Repeat the same process for all 04 (four) contact

points of the Table Legs and the Legs Support Panels.Once all the panels are

in place,proceed to TIGHTEN the screw-bolts of the legs, in a rotational

sequential manner.By this action, it allows the table legs to be locked into

position, evenly, thus reducing wobbles.Thereafter, lock all the Leg Support

Panels tightly into position.