Assembly Instruction SavE ThESE inSTrucTionS For FuTurE rEFErEncE.
inForMaTion BEFORE YOU BEGIN Before beginning assembly, make sure all parts are present. Compare parts received with the “Parts List.” If any part is missing or damaged, do NOT attempt to assemble the product. Please read and understand this entire manual before attempting to assemble, operate or install this product. GENERAL INFORMATION Your new patio furniture is made from the finest materials available. It should provide many years of enjoyment with minimal care.
PARTS LIST A B ParT DEScriPTion QuanTiTY A Rotary Table 1 B Rotary Ring 1 C Table Top 1 D Legs Support Panel 4 E Table Leg 4 harDWarE conTEnTS C G 6x40mm Bolt/ Plastic Nut (6mm) Qty: 4 D (3 for assem + 1 extra) H I 6x15mm Bolt 8x30mm Stud Qty: 4 Qty: 5 (3 for assem + 1 extra) J K Washer/Spring Washer /nut/Plastic cap ( 8mm) Qty: 13 8x35mm Stud E Qty: 9 (8 for assem + 1 extra) L Washer/SpringWasher/ nut/Plastic cap ( 6mm) Qty: 4 (3 for assem + 1 extra) M Wrench Qty: 1
ASSEMBLY Step 1 N I C Place the Table Top(C) with the underside facing skywards. Fit the Stud(I) by turning into the 4 points on the underside of Table Top(C) with the Screwdriver(N). Step 2 N J Fix the Stud(J) to the Table Leg(E) by using Screwdriver (N). Step 3 E M K K K Next, attach Table Leg(E) to studs on Table Top(C) using Washer, Spring Washer and Nut(K) with Wrench(M) . DO NOT tighten, yet.
ASSEMBLY Step 4 D D D K M NOTE: To HOLD the legs together in positon, the LEGS SUPPORT PANELS WILL OVERLAP AT ALL 04 (four) CORNERs. First, attach the Leg Support(D) with Groove End to the Studs(J) and then attach Support Panel(D) without Groove End to Studs(J), together. Then affix the Leg Support(D) to the table legs with the Washers, Spring Washers and Nuts(K) using the Wrench(M). DO NOT tighten, yet .
ASSEMBLY N Step 5 G G G G G B G Put Bolts(G) into the hole on the inner ring of Rotaty Ring(B),then screw nuts(G) on the opposite side and tighten it with Cross Srewdriver(N) and Wrench(M).Note the screw should enter from the large circle of the tapered hole on Rotaty Ring to the small circle Step 6 N H H H A Turn the Rotaty Ring(B) so that the screw on Rotaty Ring is upward, and then align holes in the outer ring of Rotaty Ring(B) with the hole on the Rotary Table(A).
ASSEMBLY Step 7 L M Put Rotary Table (A) on Table Top (C) align bolts on Rotary Table with holes on table top,insert Bolts into the holes.Then affix the Rotary Table to the Table Top with the Washers,Spring Washers and Nuts (L) using the Wrench (M).Add Plastic Caps on all bolt ends.Adjust the leg pre-installed Levellers until the Table is level with the ground.
