Use and Care Manual

Tighten all Nuts.

Hardware Used: G Bolt 6X30mm x6

I Washer/Spring Washer/

Nut 6mm x6

Attach the Round Leg Support Cbetween the 3 Legs

using Bolts G and Washers/Spring Washers/Nuts I.

Lay the Table Top A upside-down on a nonabrasive

surface. Fix the Studs J into the Table Top, then fit the

three Table Le

gs B over the fixed Studs J

and secure using

Washers/Spring Washers/Nuts H. DO NOT OVER-TIGHTEN.

Hardware Used: J Stud 8x30mm x3

H Washer, Spring Washer,

Nut 8mm x3

ASSEMBLY — TABLE