Assembly Instruction SavE ThESE inSTrucTionS For FuTurE rEFErEncE.
inForMaTion BEFORE YOU BEGIN Before beginning assembly, make sure all parts are present. Compare parts received with the “Parts List.” If any part is missing or damaged, do NOT attempt to assemble the product. Please read and understand this entire manual before attempting to assemble, operate or install this product. If you have any questions regarding the product, please contact customer service. GENERAL INFORMATION Your new patio furniture is made from the finest materials available.
PARTS LIST A ParT DEScriPTion QuanTiTY A Table Top 1 B Leg 3 C Round Leg Support 1 D Backrest 2 E Seat 2 F Chair Leg 8 B harDWarE conTEnTS C G 6x35mm Bolt Qty: 7 (6 for assem + 1 extra) H Washer/Spring Washer /nut/Plastic cap (8mm) Qty: 24 (23 for assem + 1 extra) D I Washer/Spring Washer /nut/Plastic cap (6mm) Qty: 7 E (6 for assem + 1 extra) K F Wrench Qty: 1 J 8x30mm Stud Qty: 4 (3 for assem + 1 extra) L adjustable Foot Qty: 11 (Pre-Installed) 3
ASSEMBLY — CHAIR PrEParaTion Before beginning assembly, be sure to empty contents of carton and make sure all parts are present.Place all parts on a soft, level surface for assembly. Estimated Assembly Time: 60 Minutes | DO NOT over tighten hardware! the Backrest D to the Seat E by inserting the 1 Fitprefixed studs into the two holes on the seat. Bolt together using Washers/Spring Washers/Nuts H. Tighten the Nut using the Wrench K. Repeat with second chair.
ASSEMBLY — TABLE Lay the Table Top A upside-down on a nonabrasive surface. Fix the Studs J into the Table Top, then fit the three Table Legs B over the fixed Studs J and secure using Washers/Spring Washers/Nuts H. DO NOT OVER-TIGHTEN. 3 Hardware Used: J Stud 8x30mm x3 H Washer, Spring Washer, Nut 8mm x3 3 the Round Leg Support C between the 3 Legs 4 Attach using Bolts G and Washers/Spring Washers/Nuts I. Tighten all Nuts.
ASSEMBLY ALL hardware on table and chairs using Wrench K. DO NOT OVER TIGHTEN. 5 Tighten Adjust the pre-installed Rubber Feet L until the Bistro Set sits level on the ground. Finally, cover all Nuts with Plastic Caps I/H.
