Alfred DB-B Installation guide SCAN FOR [w] POWERED Bi Alfred International Inc. reserves all rights for the final interpretation of the following instructions. A\ All design and specifications are subject to change without notice ENVELOPER
Outside escutcheon Status indicator 1# Cylinder cover Cylinder Inside escutcheon Reset button Speaker Status indicator 28 Touch screen keypad Wireless module — 0 socket — =] Status indicator 3¢ (Sa Status Indicators 1#. Door secured 2#, Door unlocked 3#.
THIS SDE AGAINST DOOR Outside escutcheon Inside Mounting plate escutcheon Reinforcement Plate Latch bolt Strike plate 2/6 Battery cover X4 AA alkaline battery I x KA4*40 — #8 32*30 x2 x1 BM4*§ KM4*6 x2 KA4*20 x1 Optional 3rd Post May come per-installed on Lack, can ba removed with pullers x1 Rotation shaft x2 Override key Screw pack
Tools Needed Lock Installation #2 Philips screwdriver BTA MN T Door prep (Optional Tools, only required if installing lock on new The handing switch sends to be put in the door without existing Lock Prep)) direction the latch bolt is sliding when 1. 53mm hole saw looking at the inside of your door. 2.17 26mm boring bit 2.5mm drill bit 10mm drill bit 5. Chisel&Hammer PREPARE LOCK FOR INSTALLATION Unpack the Lock A. Inside escutcheon Confirm door handing direction.
Installation A NOTE: Make aura to allow for the bolt to be centered In the strike. Make sure that the arrow at the tail end is pointing upwards. NOTE: The bolt must be in retracted{Unlocked) position when Installing the locket. NOTE: Check to make sure bolt fully extends @hr—— 4/6 @ Er area X2KA4*20 The 3rd Top Post is OPTIONAL. The Top Frost is used for additional security, or when a door Is weak or warped. The Top Post can be easily removed by unscrewing with a pair of pliers and discarded.
Installation NOTE: 3rd Post on Top is OPTIONAL. 48-32430 /I\NOTE: Do not over-tighten. PCB compactor Cable connector NOTE: Tail piece must ba in the horizontal position when properly installed.
Installation NOTE: The horizontal orientation of the tailpiece as you insert the ins inside escutcheon(thumb turn should be vertical} P NOTE: Test operation using thumb turn before installing Install Wire © batteries to make sure latch bolt extends smoothly. le | rattly a If latch bolt does not extend, please check that the tail pace was inserted correctly.
Congratulations, you have installed the Alfred DB-B Touch Screen Smart Deadbolt. Please now download the Alfred Home App from either tha Apple App Store or Google Play Store to set up your Master PIN Code for the lock or refer to Programming Instructions booklet provided. Download the Alfred Home App Alfred Home PETITION LEE ETE TY RNR Ge For support, please reach out to: You can also reach us at 1-833-4-ALFRED (253733) www.alfredinc.
