Installation Instructions
8
INSTRUCTION FOR USE
BE
FORE USING THE PRODUCT
Please read these instructions carefully before beginning
installation to ensure the appliance is installed safety an
d
correctly.
In
stallation should be performed by qualified professional
only. Local installation standards shou
ld be applied.
B
efore any operation remove the packaging and ch
eck
applian
ce integrity. If any defect or damage are no
ticed do
n
ot install or try to repair the appliance but inform the
retailer.
The packaging should be kept out of reach of children an
d
disposed in
accordance whit the national regulations fo
r
w
aste processing.
Do not modify or disassemble the appliance. Do not remove
the ceramic heater. It may cause fire, electric shock or inju
ry.
Th
is appliance is designed and produced for home use only
and is not suitable for installing and using in public places or
on vehicles, boats or aircraft.
FOR YOUR SAFETY
Use a single-phase alternating current 110/120 VAC, 60 Hz
power supply. Voltage in excess may cause malfunction
, so
stay w
ithin the rated range.
Electrical wiring work should be done by a certified
professional in conformance with local standards.
Be sure to install a ground-fault circuit interrupter with idn <
30 mA
.
Th
is is a CLASS I electric insulation appliance and must
be
properly g
round
ed.
If
the electric cable or the plug are damaged and ha
s to be
repaired do n
ot perform this repair by yourself. Bring the
product to a qualified repair centre and have them repaired
by specialised personnel in order to avoid any risk of
damage.
Never use the product in rooms that are saturated with
explosive gas, vapours generated by solvents or paints or any
other flammable vapours or gas.
This appliance is not intended for use by young people or by
persons who possess limited physical, sensorial or mental
capabilities unless they are adequately supervised by a
responsible person to ensure that they can use the appliance
safely. Young children should be supervised to ensure that
they do not play with the applianc
e.
N
ever allows animals or children to play with or touch the
applianc
e.
A
ttention! When turned on, the panel may become very hot.
Attention this appliance is intended only for drying textiles
washed in water.
Never leave your home while the appliance is turned on
;
m
ake sure the illuminated switch is OFF and the red light
is
o
ff.
SAFE POSITIONING
Never install the appliance on a surface made of wood or
synthetic material.
Always place this appliance in vertical position so that
the
sw
itch results on the down side of
it.
Do n
ot climb on the appliance.
Never place this appliance immediately underneath a power
socket.
Alw
ays make observe the minimum distances from wall,
furniture or other objects as showed (fig. A)
.
Th
e appliance has a grade IPX4 water protection. The produc
t
m
ay be used in bathrooms or humid places as long as th
e
sa
fety zones are respected. In any cases avoid installing th
e
a
ppliance in location where there is a lot of condensation.
It must never be possible for person in the bath tu
b or
sh
ower to reach the power switch
.
INSTALLATION
Expansion plugs and screws, provided with the product, are
on
ly suitable for concrete or solid brick walls. For different
wall material types, use the appropriate fixing means.
ELECTRICAL CONNECTIONS
The product must be powered at a voltage of 110/120 VAC,
60 Hz.
The product is supplied, depending on type, with a Schu
ko
plu
g cable to connect to a proper efficient earthed socket, or
with a 3 core cable ending with a connection block for a
permanent installation to the main power supply.
If the product is supplied with cable, connect it to the main
power supply, by means of the provided connection box,
using a 3-wire cable
Use the proper provided rubber gland to guarantee the
sealing of the main supply cable passing through th
e
c
onnection box. Multi core cable (MAX ø 9 mm)
Single core cables
USE OF THE PRODUCT
By means of the illuminated switch the towel warmer can be
switched on and off.
Carefully arrange the towels without overlapping them in
order to optimise drying time and appliance temperatur
e.