Installations

丘 9 1 2
3.A 而 .er ∞ nnecting hot and ∞ Id supply , tum on mixer to check
for leakage with testing water p 陪 ssure ~ 1.6MPa 但 32psi).
After testing , install protective ring( 11) onto the base , then ,
fumish the floor according to 伽 e ∞ nstruction. Remove the I
1 4.lnstall the mainbody(1) as shown on the Fig. Fix the main
pro 怡 ctive ri 吨， screws(3) , spring gas 阳恼 (4) ， protective board l
I body on the base with screws and spring gaskets.
(5) and rubber plugs(6) when the cement is dry. I
5.Tighten screws(3) with allen key(12). Then ∞ nnect hand 1 6.Check for leakage after installation. Finally , push down
showe r( 9) and Main body with shower hose(10). I the decorative plate (2) close to floor.
-3-