Datasheet

POWERVERTER PV65R
12/24VDC USB CHARGERS WITH IP65 PROTECTION
USB POWER WITH ADDED LIQUID & DUST INGRESS
AND VIBRATION PROTECTION TO IP65
The PV65R range of USB chargers offers all the performance benefits of the PVPro
range with additional protection provided to the electronic circuit of the unit. A
durable polyurethane compound encompasses the electronic components offering
comprehensive protection against dust and liquid ingress to IP65.
This product offers a good solution where tampering might be an issue or in dirty or
more challenging environments. Although the nature of the USB connector itself can
always be wilfully broken or damaged and will still corrode if repeatedly exposed to
liquid ingress, all electronics in these units is protected to IP65.
THE RANGE
The range mirrors the very successful PVPro
products, offering both single and double outputs
and rear fit as well as front fitting options which
allow the unit to be replaced quickly and easily
should this be required. Automatic short circuit
protection is also included, so in the event of
tampering or compromise, the unit will
automatically shut down, then re-start once the
fault has been removed. All units can be installed
on both 12Vdc or 24Vdc vehicles without
adjustment.
Units can be installed directly into bulkheads,
vehicle walls, into seat fittings and underneath
seats using the mounting pod P/N USB-POD. They
can also be fitted onto table tops using the
horizontal surface mounting pod P/N USB-TPOD.
APPROVALS AND
MANUFACTURE
The range has been designed
to meet the rigorous standards
required for on board
commercial vehicle applications
including EN50498, ISO7637-2,
EN61373 and EN50155 and is
both CE and E marked (Reg10).
The casings are made from
V0 rated (self-extinguishing)
high impact polycarbonate
and the electronic assembly
is predominantly by computer
controlled SMT for maximum
durability.
• Designed for demanding
environments including bus, coach,
off road and railway applications.
• Electronics protected to IP65.
• Extra vibration protection to
EN61373.
• Approved to EN50498, ISO7637-2
and EN50155. E marked (Reg10)
and CE marked.
PowerVerter PV65R-S and PV65R-D
single and double outlets.
The Front facing version can be
screwed in place from the front, then
covered with the attractive ring to
avoid tampering. Available in both
single (PV65R-SFf) and double outputs
(PV65R-DFf).
WARRANTY
The PV65R range of chargers are
manufactured using rugged
components to provide years of service
in demanding commercial environments
and are covered by a three year return
to base guarantee.
Electronic circuitry.
Standard USB
connector.
Note: as the USB
connector offers an
electrical interface
this component
can’t be protected.
Potting Compound.
- All electronics sealed against damage from
liquid, dust and impact/vibration, to IP65.
No airflow is possible between fore and rear of the unit.