Datasheet
ALFACHARGE WIRELESS CHARGER AL1-H
12/24VDC WIRELESS CHARGER MODULE
AL1 SERIES WIRELESS CHARGER MODULE FOR
INTEGRATION INTO VEHICLE EQUIPMENT
Wireless charging is increasingly becoming the preferred method of maintaining
battery power in mobile devices, with most of the latest designs from the major
manufacturers including wireless charging as standard.
The AL1 series wireless charger module is designed for integration into equipment
on vehicles to allow this facility to extend to private and public transport
applications. This module is typically housed in apparatus that enables mobile
phones to be retained in position on the vehicle during charging. Typical
applications include integration into seat back consoles and table tops.
The charging element is placed within 0.3mm of the casing exterior to allow for
maximum performance in a wide range of situations. When designing into housing
equipment, we recommend keeping the active face of the unit within 2.0mm of the
passenger accessible area.
THE RANGE
The Alfacharge range has been designed to meet the rigorous standards required
for on board commercial vehicle applications including EN50498, ISO7637-2,
EN61373 and is both CE and E marked (Reg10). The casings are made from V0 rated
(self extinguishing) high impact polycarbonate and the PCB is populated by
computer controlled SMT for maximum accuracy and durability.
Charging
coil centre.
Alfatronix
wireless
charging
module
AL1-H.
Most wireless mobile phones will connect within 5.0mm from optimal central point. If
the installation includes a base ledge (on which the phone sits) this should ideally be
placed 39.0mm from the centre of the AL1 series module for optimum performance
with a wide variety of mobile phones.
Mobile phones
with case backs
no greater than
3.0mm will
charge reliably.
When placed against a structure, wireless devices such as mobile
phones with cases less than 3.0mm thick will reliably charge.
Max 2.0mm
This is a module unit which must be installed within a further structure.
Cover or structure over the coil area should not exceed 2.0mm in
thickness.
39.0mm
Cover
Designed for integration into
passenger vehicles.
Accepts both 12Vdc and 24Vdc.
• Extra vibration protection to
EN61373.
• Approved to EN50498,
ISO7637-2 and EN50155.
E marked (Reg10) and CE
marked.
• Phone power contracts
every millisecond to
establish correct charge.
• Foreign object detection &
activation.
• Convenient wide input of
9-32Vdc for wireless charger
in one extrusion.
• LED to confirm correct
operation.
WARRANTY
The AL1 Series of wireless chargers
are manufactured using rugged
components to provide years of
services in demanding commercial
environments and are covered by a
three year return to base warranty.
It is recommended that these
units are fused individually with
a 1Amp fuse (24V systems) or
a 2Amp fuse (12V Systems).
Suitable in-line fuses are
available;
Part Numbers:
PVP-FUSE 1, PVP-FUSE 2