User Manual
Table Of Contents
- 1. Hardware
- 2. Technology Overview
- 3. Software
- 3.1 Software Installation
- 3.2 Using the Software
- 3.3 Custom edit processing module
- 3.4 Audio Module Parameters
- 3.4.1 Input Source
- 3.4.2 Expander
- 3.4.3 Compressor & Limiter
- 3.4.4 Automatic Gain Control
- 3.4.5 Equalizers
- 3.4.6 Graphic Equalizer
- 3.4.7 Feedback Suppressor
- 3.4.8 Noise Gate
- 3.4.9 Ducker
- 3.4.10 Ambient Noise Compensation (ANC
- 3.4.11 Auto Mixer
- 3.4.12 Acoustic Echo Cancelation
- 3.4.13 Noise Suppression
- 3.4.14 Matrix
- 3.4.15 High and Low Pass Filter
- 3.4.16 Delay
- 3.3.17 Output
- 3.4.18 USB interface
- 3.5 Settings Menu
- 4. Control
- 5. FAQs
- Appendix A: Module ID Distribution
- Appendix B: Module Parameter Types (1)
ALF-DSP 88-U
-52-
1.10 The Company will, at its sole option, provide one of the following three remedies to whatever
extent it shall deem necessary to satisfy a proper claim under this limited warranty:
1.10.1 Elect to repair or facilitate the repair of any defective parts within a reasonable period of time,
free of any charge for the necessary parts and labor to complete the repair and restore this
product to its proper operating condition.; or
1.10.2 Replace this product with a direct replacement or with a similar product deemed by the
Company to perform substantially the same function as the original product; or
1.10.3 Issue a refund of the o riginal purchase price less depreciat ion to be determined based on the
age of the product at the time remedy is sought under this limited warranty.
1.11 The Company is not obligated to provide the Customer with a substitute unit during the limited
warranty period or at any time thereafter.
1.12 If this product is returned to the Company this product must be insured during shipment, with
the insurance and shipping charges prepaid by the Customer. If this product is returned
uninsured, the Customer assumes all risks of loss or damage during shipment. The Company
will not be responsible for any costs related to the removal or reinstallation of this product
from or into any installation. The Company will not be responsible for any costs related to any
setting up this product, any adjustment of user controls or any programming required for a
specific installation of this product.
1.13 Please be aware that the Company’s products and components have not been tested with
competitor’s products and therefore the Company cannot warrant products and/or
components used in conjunction with competitor’s products.
1.14 The appropriateness of the goods for the purpose intended is only warranted to the extent
that the goods are used in accordance with the Company’s installation, classification, and
usage instructions.
1.15 Any claim by the Customer which is based on any defect in the quality or condition of the
goods or their failure to correspond with specification shall be notified in writing to the
Company within 7 days of delivery or (where the defect or failure was not apparent on
reasonable inspection by the Customer) within a reasonable time after discovery of the defect
or failure, but, in any event, within 6 months of delivery.
1.16 If delivery is not refused, and the Customer does not notify the Company accordingly, the
Customer may not reject the goods and the Company shall have no liability and the Customer
shall pay the price as if the goods had been delivered in accordance with the Agreement.
1.17 THE MAXIMUM LIABILITY OF THE COMPANY UNDER THIS LIMITED WARRANTY SHALL NOT
EXCEED THE ACTUAL PURCHASE PRICE PAID FOR THE PRODUCT.