User Manual

ALF-DSP 88-U
-47-
Command explanation:
del config: delete configuration information, such as network configurations like IP address. The device restores to
default IP 169.254.20.227 after deleting.
del scenes: delete preset. All 16 presets of DSP devices restore to default values.
del all: delete all sections except the program.
Note: There may be no echo after the installation of SecureCRT. Please check se ttings under “Local echo” by going
to Options->Session Options->Enable ‘Local Echo’, as shown in the picture below.
Appendix A: Module ID Distribution
Module Name ID Module Name ID
Input source 299 Output Channel 1-32 High &
Low Pass
167~198
Input Channel 1-32 Expander 1~32 Output Channel 1-32 Equalizer 199~230
Input Channel 1-32 Compressor 33~64 Output Channel 1-32 Delayer 231~262
Input Channel 1-32 Auto Gain 65~95 Output Channel 1-32 Limiter 263~294
Input Channel 1-32 Equalizer 97~128
Input Channel 1-32 Feedback
Inhibition
129~160
AutoMixer 161 Echo Canceller 162
Echo Cancellation 163 Noise Suppressor 164
Noise Suppression 165
Mixer 166
Output 295
System Control 296