User Manual
Table Of Contents
- 1. Hardware
- 2. Technology Overview
- 3. Software
- 3.1 Software Installation
- 3.2 Using the Software
- 3.3 Custom edit processing module
- 3.4 Audio Module Parameters
- 3.4.1 Input Source
- 3.4.2 Expander
- 3.4.3 Compressor & Limiter
- 3.4.4 Automatic Gain Control
- 3.4.5 Equalizers
- 3.4.6 Graphic Equalizer
- 3.4.7 Feedback Suppressor
- 3.4.8 Noise Gate
- 3.4.9 Ducker
- 3.4.10 Ambient Noise Compensation (ANC
- 3.4.11 Auto Mixer
- 3.4.12 Acoustic Echo Cancelation
- 3.4.13 Noise Suppression
- 3.4.14 Matrix
- 3.4.15 High and Low Pass Filter
- 3.4.16 Delay
- 3.3.17 Output
- 3.4.18 USB interface
- 3.5 Settings Menu
- 4. Control
- 5. FAQs
- Appendix A: Module ID Distribution
- Appendix B: Module Parameter Types (1)
ALF-DSP 88-U
-46-
5. FAQs
1. How to restore factory setting?
Conne ct the processor to a computer through RS232 and run the serial port software (SecureCRT is recommended
for use). The default baud rate of the serial port is 115200, 8 data bits, no parity check, and 1 stop bit. After
connecting SecureCRT to the serial port, long press to enter a terminal interface to reboot the computer and enter
the bootloader boot dialog box as shown in the below figure: