User Manual
Table Of Contents
- 1. Hardware
- 2. Technology Overview
- 3. Software
- 3.1 Software Installation
- 3.2 Using the Software
- 3.3 Custom edit processing module
- 3.4 Audio Module Parameters
- 3.4.1 Input Source
- 3.4.2 Expander
- 3.4.3 Compressor & Limiter
- 3.4.4 Automatic Gain Control
- 3.4.5 Equalizers
- 3.4.6 Graphic Equalizer
- 3.4.7 Feedback Suppressor
- 3.4.8 Noise Gate
- 3.4.9 Ducker
- 3.4.10 Ambient Noise Compensation (ANC
- 3.4.11 Auto Mixer
- 3.4.12 Acoustic Echo Cancelation
- 3.4.13 Noise Suppression
- 3.4.14 Matrix
- 3.4.15 High and Low Pass Filter
- 3.4.16 Delay
- 3.3.17 Output
- 3.4.18 USB interface
- 3.5 Settings Menu
- 4. Control
- 5. FAQs
- Appendix A: Module ID Distribution
- Appendix B: Module Parameter Types (1)
ALF-DSP 88-U
-32-
Save: Save the parameters to the device
Camera Settings
The camera settings section is used to set up the control parameters for each camera connected. Multiple cameras
can be added, controlled and presets assigned accordingly.
3.5 Settings Menu
3.5.1 File Menu
In offline mode, click the pop-up file dialog and open an existed default document with suffix *.uma, or right click
on the default document to open DSP.exe.
“Save as” refers to saving presets on the application to local hard risk to realize easy copy and store.
3.5.2 Device Setting
Information like device name, network address and serial baud rate can be set unde r device setting. The maximum
length of the device name is 16 characters.
Default startup: Two startup preset modes are available for selection. One is any preset from 16 presets acting as
startup preset. Each boot will start with it. Another is selecting previous upload preset and taking the last preset
before power outage as the preset for next startup.