User Manual
Table Of Contents
- 1. Hardware
- 2. Technology Overview
- 3. Software
- 3.1 Software Installation
- 3.2 Using the Software
- 3.3 Custom edit processing module
- 3.4 Audio Module Parameters
- 3.4.1 Input Source
- 3.4.2 Expander
- 3.4.3 Compressor & Limiter
- 3.4.4 Automatic Gain Control
- 3.4.5 Equalizers
- 3.4.6 Graphic Equalizer
- 3.4.7 Feedback Suppressor
- 3.4.8 Noise Gate
- 3.4.9 Ducker
- 3.4.10 Ambient Noise Compensation (ANC
- 3.4.11 Auto Mixer
- 3.4.12 Acoustic Echo Cancelation
- 3.4.13 Noise Suppression
- 3.4.14 Matrix
- 3.4.15 High and Low Pass Filter
- 3.4.16 Delay
- 3.3.17 Output
- 3.4.18 USB interface
- 3.5 Settings Menu
- 4. Control
- 5. FAQs
- Appendix A: Module ID Distribution
- Appendix B: Module Parameter Types (1)
ALF-DSP 88-U
-15-
3.4 Audio Module Parameters
There are two ways to access the audio module parameters: first, click the input or output channel module you
wish to acce ss, and enter the parameter interface of the module; secondly, right click the channel module and the
configuration interface will pop out. This is used for the following module parameters.
3.4.1 Input Source
Sensitivity: Microphone gain, 0dB - 48dB in 3dB Steps.
Phantom Power: Provides +48V phantom power for external condenser microphones. (Do not enable phantom
power when the power is not required, this is to prevent damaging any non-Phantom powered devices when
connected.)