User manual

AlfaSpid Rotator www.alfaradio.ca Page 11

- AlfaSpid

- Yaesu

(GS232 protocol, 600 baud N, 1, 8 bits)

(Data rate 600, 1 STOP bit, no even parity bit)

Operating mode change

, .

- Heading Adjust

This setting can be used to make minor heading adjustments

without causing the rotator to turn. If you notice that the heading

displayed on the controller to a known signal source is out by a few

degrees, you can change the heading displayed on the LED readout to

match the known heading, rather than having to turn back to North and

reset the controller. These settings are made by

, , , buttons.