Instruction manual

www.alfaradio.ca AlfaSpid Rotator Page 13
Page 13 of 23 A lfa Radio Ltd. 11211 - 154 St. Edmonton, Alberta, Canada T5M 1X8 780 466 5779
AlfaSpid_Rotator_RAK_Manual_Sept15_2008.doc
- Program Simulation
Program Simulation allows the user to set the serial communication protocol
used by the rotator. When set to emulate another brand of rotator, the AlfaSpid
will respond to commands, and send responses back to the computer as if it
were the rotator brand selected. If your favourite software supports a rotator,
chances are, the AlfaSpid will be able to interface to your software. There are 4
modes available: Note: some programs may not support the 1200 Baud
requirements of the controller in emulation mode.
- Spid ( AlfaSpid ) Recommended
- Orion
- Hygain
- Yaesu
- Heading Adjust (numbers blinking)
This setting can be used to make minor heading adjustments without causing
the rotator to turn. If you notice that the heading displayed on the controller to a
known signal source is out by a few degrees, you can change the heading
displayed on the LED readout to match the known heading, rather than having to
turn back to North and reset the controller.