User Manual
14 15
GAS ORIFICE AND PILOT SPUD CONVERSION
ONLY USE THE COMPONENTS AND
PARTS SUPPLIED WITH THE CONVERSION KIT
WARNING: The following conversion should be performed by authorized
See next page for proper spud and orce component numbers
1 - GAS KIT DISASSEMBLY
according to the
instructions in the
appropriate section of
the manual.
2 REPLACEMENT OF THE
MAIN GAS NOZZLE
(a) and remove the plate (b)
the main nozzle (e) to the
holder screw (d) by using an
11 mm spanner. Replace the
in the
holder (d)
nozzle holder (d)
from rotating.
d
e
a
b
continue next page >>
3.1 REPLACEMENT OF THE PILOT
SPUD
(h) of the
pilot light tube..
3.2
Remove the tube (i) from the seat.
3.3
Remove the pilot nozzle ( j) from the
(o) and replace
it with the spare component
Reassemble everything following the
same steps in reverse order.
h
i
o
Following the conversion, apply the new label on the product and
check that the size of the nozzle corresponds to that shown on the label.