Technical data

PRELIMINARY
OPERi+TION,S
1. Remove #drive unit from car ac-
cording t8 procedures: Drive Unit
Removql An4 Installation.
2. Remove Qearbox - differential unit
and clutcq uni? from engine according
to ‘proc&d,ures: Separation and As-
semblv, of the’ Units (sec: “WORKSHOP
MANUiL c-1’ ”
- Group O-l ).
,’
ENG$E ‘UNIT
The engin? is on the stand without inlet
manifold #and’ with no spark plugs,
tables, a,nd distributor cap already
rehoved on engine removal.
,l
1. Re’mpval ,of fnjection wiring
(1) Di&onnect injection wiring con-
nectors $om following components:
-
supplementary air valve
-: pow&r module on ignition tem-
peiature
-
engine tiater temperature sensor
- Imje&ors’
Disenglge viring from wire clips and
remove $iring from engine
2; Reniove fuel distribution manifold.
(1;) Unsciew fixi,ng screws from bracket
@ supporting damper @ and
pressure gauge @
(2) Uns,crew screws (two per side) fix-
ing bradkefs @ which support the
fuel hose 0.
(3) Remove fuel hose disconnecting
it from fouy injectors @.
(4) Rehove four injectors @, ex-
tracting, them from thermal switches
May19i8,
4. Remoie spark plugs and ignition
qlistributor.
(1) Unscrew and remove spark plugs
from cylinder heads.
(2) Loosen distributor @ securing
nut @ and withdraw distributor from
rear caver.
1 Bracket
2 DalrIper
3 Fuel pressure gauge
4 Intake manifold
5 Bracker
6 Injecter
7 Fuel supply hose
1 Ignition distributor
2 Distributbr securing nut
,3. Sequentially remove’the followinb
parts:
-
Oil filter @ &ing suitable span-
ner.
-
Dipstick @ for minimum Oil
pressure check
-
Thermal switch @ from right
cylinder head.
1 Oilfilter
2 Pressure switch
3 Dipstick
4 Thermal switch
~
i
5. Remoue alternator.
(1) Loosen securing bolts @ fixing
alternator @ and remove drive belt.
(2) Remove bolts and take out alterna-
tor (2).
(3) Unscrew screws @ and remove
bracket @ and @ .
,B :
1
2
3’
4
5
Bolt ~
Alternator
Screws
Bracket
Bracket
OI-12
PA333500883300
‘,’