Technical data

ENGINE MAIN :MECHANICAL UNIT
11. Removal of electrical tables
Operatè as described at step 11 page
‘01-5 with reference to Fig. page 01-4.
12. ~Loosening nut of engine central
support
Operate as described at step 12 page
03-5.
For’following procedure steps refer to
Figure at page 01-6.
13. :Oil drain’ing
(if required, as a function of interven-
tion to be carried out, operate as de-
scr/bed at step 13 page 015).
14.‘Removal of exhaust pipe.
a. Disconnect exhaust gas manifolds
from right and left engine heads, un-
screwk-rg the relevant fixing nuts 18.
b. Discqnnect exhaust pipe on vehicle
rear side unscrewing screw of connec-
ting clip to final trunk of exhaust pipe
and remove it from elastic support.
Removal of ,reversing light table
Disconnect reversing light table 11
from gearbox switch.
16.~ Mechanical disconnection and re-
moval’ of drive unit.
‘8
Operate as ‘described at step 16 page
dl-~5.
INSTALLATION
1.7 IE without catalytic converter
1. Preliminary operations
Operate as described at step 1’ page
01-7.
2. Reinstallation of reverse light table
and of exhaust pipe.
a. Reconnect reverse light table to
gearbox switch.
b. Remount exhaust manifold opera-
ting in reverse order to removal, with
new gaskets between manifolds and
engine heads.
3. Reassembly of electrical tables.
Lower the auto lift and, with reference
to figure on page 01-4, reconnect elec-
trical tables working in reverse order
to that described T “Removal” step 11.
For following,procedure steps, refer to
Figure 07-3.
4. Reassembly of clutch control hose
Refit hose @ to clutch pump and ful-
ly tighten it.
5. Reassembly of air intake manifold
Refit inlet manifold @ on intake ma-
nifolds, fitting new gaskets, then tigii-
ten securing nuts.
Mind that the central nuts on two si-
des of manifold serve also fix brackets
0
OI-811
6. Completion of reassembly
a. R,econnect injectionlignition wiring
in reverse order to that described un-
der !‘Removal” step 8.
b. Reconnect accelerator table to le-
ver @ ON THROTTLE BODY.
c. Reconnect hoses
@
and @ re-
spectively to damper
@
and pressu-
re gauge 8.
d. Reconnect pipelines of engine coo-
ling system in reverse order to that de-
scribed under “Removal” step 5.
e. Reconnect tables supplying spark
plugs and reinstall ignition distributor
Cape 0 .
f. Reinstall air filter caver
0
, air
flow sensor 0
ve G9
and corrugated slee-
in reverse order to that descri-
bed under “‘Removal” step 2.
g. Remount hood.
h. Remount battery negative terminal.
i. Operating inside the passenger com-
partment refit the gear lever knob and
rubber gaiters in the gear lever.
REFILLING AND
ADJUSTEMENTS
a. Refill engine and gearbox-
differential with type and quality of oil
recommended.
WARNING:
Before refilling with oil, make sure
that the engine pump drain plug and
gearbox drain plug’have been screwed
back on.
October 1988