Technical data

~
r
ENGINE MAIN MECHANICAL,,UNIT
g. Unsciew and remove the two bolts
0:
connectimng the front cross mem-
ber t’o the left $rut @ .
h. Swing the front cross member
round as shown in the illustration to
allok the drive unit to be taken out
downwards.
i. Unscrew and remove the two screws
fixiqg the drivce unit rear support
0
to tbe body.
1. Remove boit fixing engine central
supbort to body, unloosened at step
12.
m. l!ower column lift and take the drive
uhit out from the engine comp,artment.
I’
‘1 ,,
:l
~
Ih$T;ALLATION
11.7 IIE w;ith catalytic con-
v,erter
1. ereliminary Operations
CAbTiON:
Dribe unit assembly must be perfor-
me:d in such a way that the gfearboz
rear support and the engine front sup-
port are not respectively upwards and
longitudinally preloaded.
a. Raise the drive unit wi!h the column
lif{er used for disassembly until the
centre ,support axis
0
is ai about
the halfway point of the body slot and
tighten the relevant boit 0.
PA327900883301
,
1 Boit
2 Central support
b. With referdnce to figure at’ page
01.6, rotate the front crossme,mber
complet@ with stabilizing bar in moun-
ting position and fix it with bolt @ to
strut
@ then fully tighten bolts @
and 0.
c. Tighten screws 4 fixing the engi-
0
ne front support.
d. Tighten !he foilowing components
to !he specified torque.
0
Tightening torques
* cro&nember an6 stabilizing
bar bïacket to body
66,5 + 83,3 N.m
(6,s + 8,5 kg.m)
l Screws fixing stabiliting bar
to strut
14,7 i 23,5 N.m
(1,5 + 2,4 kg.m)
l Screws connecting semishaft
. differential shafts (in ‘engine
oil)
33 + 36 N.m
(3,4 + 3,7 kg.m)
e. With reference to following figure
remove lift and loosen lower b&t @
vant poitit fixing it to body and’tighten
screwS 0.
g. Retighten lower nut @
01-7
1 Rear support of gearbox
2 Pin
3 Rear support securing screw
4 Bolt securing gearbox rear support
h. Insert the side rod @ into support
on right side longitudinal member
@ first and
1 Ri,ghl cylinder head
2 Right side longitudinal member
3 Support
4 Side rod (engine antishock bar)
5 Front screw
6 Rear screw
2. Reinstallation of reverse light table
and of exhaust pipe
a. Reconnect the reverse light table to
gearbox switch.
b. Remount exhaust mainfolds in re-
verse order with respect to removal,
new gaskets between mainfolds and
engine cylinder heads and between
mainfolds and catalytic muffler.
October 1988