Technical data

(3) Unscrew nuts @ securing cata-
SUPPORT RINGS ”
lytic muffler @ and exhaust manifold
‘I@. ~
Verify integrity of support rings and
(4) Free! cetalytic muffler @ support
replace them if necessary.
brackets! from lock rings @ and
remove it.~
4. Remove manifolds @ as follows:
(1) Disconnect manifold @ from
INSTALLATION
catalytic muffler unscrewing nuts 0.
(2)’ Loqsen nuts @ securing
Fit single parts back together follow-
manifold fl8nges to cylinder heads and
ing removal operations in reverse se-
then remove rear element @ and
quence and paying close attention to
gasket ‘0.
below instructions:
04-24
a. Always fit new gaskets between \
manifold flanges and cylinder heads,
.’
and on flange between muffler and ex-
haust manifold.
b. Having completed installation,
check and make sure that support
rings move freely and are free of un-
due’ stress; check brackets making
sure they have been properly secured.
c. While engine is running check all
pipe connections for gas leaks and the
whole exhaust system for unusual
noises.
PA333500883300