Technical data

FUEL SYSTEM
2. Disconnect’ valve @ from fuel
recovery tube circuit.
FUEL, VAPOUR
SEPARATOR
REMOVAL AND ASSEMBLY
1. Move, away left side covering of
trunk. :
2. Loosén Aamps and disconnect
tubes 0~ and @ from separator.
~
i
3. Unscrew the two securing nuts
indicated in the fig,ure and remove the
separator ~ @
1 Retainer valve
3. Ceck that valve works properly that
is, that otherwise, replace valve it allows
the passage of air only in the direction
shown by the arrow.
Fuel vapour recovery tube
Dump valve
Depression tube
Supply tube to fuel vapour filter
1
1 Fuel vapour recoverv tube’
Proceed to assembly operating in
2 Fuel vapour separator
3 Fuel vapour exhaust pipe
reverse order in respect to removal,
properly repositioning the valve as
shown in previous figure.
4. If nec!essary, blow compressed air
inside the separator to clean it.
5. For essembly, operate in reverse
order in respect to removal.
4. Proceed to assembly in revers&
order in respect to removal, properly
repositioning the valve as stated in the
figure in step @
FUEL VAPOUR FILTER
DUMP VALVE
COMBPENSATION VALVE
REMOVAL AND ASSEMBLY
REMOVAL AND ASSEMBLY
1. Discohnect tubes 0, 0, and
@ from filter.
REMOV:AL, CHECK AND
INSPECTIONS, ASSEMBLY
i
1. Partially remove the trunk left side
coverin&
1. Operating in the engine compart-
ment, front left area’below fuel vapour
filter, remove valve @ from tubes
@,@,and@.
2. Unscrew fixing screw positioned
under filter @ , lift it and remove it.
04-l 8 PA333500883300
May 1’988