Technical data

II
FUEL SYSTEM
3. Remove lock ring 0
and discon-
nect’sheath @ from bracket a
4. Disconnect wiring
@.
5. Dfsconnect tube @ from throttle
body.
6. Ldosen clam s and disconnect tu-
bes @ and 3 from manifold 0. 6
7. Disconnect tubes
63 C$d @
from manifold and tube @ from
throttleibody; (only for models with ca-
talytic converter).
6. Unscrew fixing
c9
and separate
servobracket depression tube from
manifold.
9. ‘Loosen clamp and disconnect slee-
ve @ ‘from throttle body 0.
PAd279E0883301
10. Unscrew three nuts @
on each
manifold end and remove manifold
with gasket 0.
Central nuts also secure the engine lif-
ting brackets @ .
11. If necessary, remove four screws
@ and separate throttle body @
with gasket @ from manifold.’
Two u per screws also secure brac-
kets 8 .
6
04-13
ASSEMBLY
Proceed to assembly operating in re-
verse order in respect to removal, fol-
lowing these,‘instructions:
.
Fit new gasket between:
,-
Throttle body and manifold
- Manifold and ducts on
heads.
.
~ Effect check and, if necessary,
‘adjust accelerator control table
(see: Group 00)
.
Effect check and, if necessary,
adjust idle rpm (see: Group 00).
October 1988