Technical data

FUEL SYSTEM
6. Disconnect depression tube
0.
7. Unscrew four fixing screws and re-
move throttte body @ and gasket
from supply~,manifold @ .
The two upper screws fix braket @
aswell.
~ImNTAK~ ~MANFOLD,
(AIR INTAKE BOX).
REMOVAL
Proceed to assembly operating in re-
verse order in respect to removal, fol-
lowing these instructions:
.
Fit a new gasket between throttle
body and intake manifold.
.
Effect ‘calibration and setting
(see: Calibrations and Settings).
1 Cracket fixing accelerator table sheath
2 Throttle body
3 Depression tube
4 Supply manifold
1 Intake manifold
2 By-pass tube to set idle rpm
3 Supplementary air feed tube
4 Servobrake depression tube fitting
5 Gaskets
6 Throttle body switch wiring
7 Cooling,system breather pipes
6 Sheath fixjng bracket of acceleratorcable
9
10
11
12
13
14
Throttle body fixing screw to
manifold
Corrugated sleeve
Accelerator control table
Lock ring
Accelerator table sheath
Depression tube for ignition advance
pneumatic regulator
REMOVAL
1 /
With reference to figure, operate as
follows: ~
1. Remove air filter caver and air flow
sensor.
Qctober 1988
04-l 2
15 Throttle body
16 Gasket
17 Depression tube for fuel vapour cleaner
(for models with catalytic converter only)
18 Depression tube for fuel pressure
19 Engine lifting bracket
20 Nut fixing supply manifold
2. Rotate accelerator control lever and
unhook pawl at accelerator table end
0.
PA3279E0883301’