Technical data
FUEL SYSTEM
r
SUPPLEMENTARY AIR
SOLENOID VALVE
CH~ECK
AND ISPECTIONS
1;
Check solenoid valve opening
a. Make sure that the engine is
cold,
then start and throttle several times
outlet tube
0
of solenoid valve
@
b:
Check that engine rpm falls and con-
tinues
ito
fait
with the passage of time
(at
rooin
temperature of
20°C
no
fall
in
r.,p.m.
Will
be
noticed
after 3
minutes).
2. Check solenoid valve closing
V$fh
the engine at normal running
tem-
peratu’re,
throttle outlet tube
0
of
so-
lenoid,valve
and make sure that engine
rpm
does
not decrease.
4. Remove plastic
caver
@
.
6Unscrew the two
ftgure-shown;bolts
fixing starter
0
and remove it.
One
of the bolts fixes ground supports
8
and battery negative terminal
1
.
i@
1 Air outlet tube
2 Supplementary air solenoid valve
3 Air inlet tube
REPLACEMENT
1. ~ Disconnect battery negative termi-
nal.
2,~Remove
air
filter
caver,
air flow
sen-
~r~~~o~~~~$~l~~@
and
@
from
starter 3 .
PA3279E0883301
I-Baftei~ negativë
cible
2 Ground support
3 Starter
4 Starter energization
table
6
Starter supply
table
6 Cover
6. Disconnect connecter
0.
7. Loosen clam
s and disconnect tu-
bes
@
and
4
from solenoid valve.
d
6.
Unscrew
fixin
screws and remove
solenoid valve
3
.
Q
9. Proceed to assembly operating in
reverse order in respect to
removal.
04-I 1
1 Air outlet tube
2 Solenoid valve control
table
3 Supplementary air solenoid valve
4 Air inlet tube
THROTTLE BODY
REMOVAL
1. Rotate accelerator control lever
@
and withdraw pawl on end of accelera-
tor table.
2. Remove
lock
ring and withdraw
sheath end from
bracket
@
3. Loosen
clamp
and disconnect tubes
@
from throttle body
@
.
4.
IDisconnect
connectar
0
from
switch.
5. Loosen fixing clamp and disconnect
sleeve
@
from throttle body.
1 Sreather tubes of engine
COOting
system
2 Acceterator throttle switch
connecter
3 Corrugated sleeve
4 Accelerator control lever
5 Bracket
6 Throttle body
October 1988